Integrating seamlessly with your Altitude32 A/V preamp, both visually and technically, the Amplitude8 uses two linear power supplies based on heavy-duty toroidal power transformers, this allows for a powerful three-dimensional soundstage huge dynamic range and bass impact only found in the best commercial theaters.
With the Trinnov Amplitude8, the Trinnov Altitude32 gets a worthy amplifier at its side. Equipped with dual power supply, ground terminal, trigger with feedthrough and DB25 connection. The huge dual power pack and the elaborately cooled Hypex NCORE power amplifiers sound powerful and pleasantly fine-grained: That’s really high end !
Raphael Vogt, Lowbeats.de (Germany)
The two linear power supplies based on heavy-duty toroidal power transformers allow every module of the Amplitude8 to deliver 225W into 8 ohms, 375W into 4 ohms and 500W into 2 ohms.
The amplification stage of the Amplitude8 also features the industry’s lowest distortion and noise specifications, and its performance is frequency-independent.
The Amplitude8 integrates seamlessly with your Altitude32 A/V preamp, both visually and technically. The Amplitude8’s input level perfectly matches the Altitude32’s output level, ensuring an optimal use of the dynamic range at the amplification stage; the Altitude32’s outputs can easily be connected to the Amplitude8’s input via D-Sub or XLR cables; the Amplitude8’s front panel was designed to match the Altitude32’s facade and will look magnificent in your home theater’s rack. A/V preamp, both visually and technically.
The Amplitude8m incorporate a new “sleep” circuit. When the amplifier stays idle for a period of more than 10 minutes, power is removed from the output modules and a front-panel LED begins to flash. As soon as an input signal is detected again on any channel, normal playback operation resumes instantaneously.
1 Balanced (XLR) per channel on each module.
47 kOhms, each phase.
6.15V RMS balanced input (+18dBu) for 225W into 8 ohms.GAIN 19.2dB.
Pin-2 = Positive, Pin-3 = Negative for Non-Inverting Output.
One balanced output with 5-way binding posts per channel.
225W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz
375W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz
500W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz
+-0.5Db From 0Hz To 20 Khz, Load Independent
> 6000 At 100 Hz; > 2000 At Any Frequency Up To And Including 20 Khz
Signal To Noise Ratio:
125Db Referenced To Rated Output (A-Weighted)
Crosstalk :85 Db
117V AC, 15A Slo Blo main fuse; 230V AC 8A Slo Blo main fuse; 50/60 Hz
less than 1W at Standby; less than 80W at idle; 1500W maximum by 2 when fully loaded
Trigger input :
5 to 12V DC; Steady State.
(W x H x D) 443 x 186,5 x 502 mm